You did mean the Pictor is ID=4 LUN 0 ? or are you really using different
LUNs (Logical Unit Numbers)? Is there anything else on the SCSI bus? Have
you changed any of the defaults for the Adaptec card?

I've just bought that same SCSI card to go in my own desktop so I'll try it
when I get chance, I normally use a SlimSCSI 1460 on my laptop.

Chris Heapy

> ----------
> Sent: 21 April 1999 07:42
> Subject: [M]: 416xt SCSI settings
>
> I have just upgraded to a 400MHZ desktop with Win98 but have been unable
> to
> get my 416xt up and running again. I am, and was previously, using an
> Adaptec
> AHA2940AU PCI and everything worked fine. Now on bootup the SCSI card
> recognizes the 416 but when I start the Pictor software and try to connect
>
> the camera nothing happens.
> The SCSI card is IRQ=10, Pictor is IRQ=4 (LUN 4), the camera settings in
> the
> Pictor preferences are set at IRQ4 and SCSI ID 4.
> What do I have wrong? Can anyone send me the correct SCSI settings to use
> at
> bootup to reconfigure the SCSI card?
> Thanks in advance
> Max
>

View index by [date] [author] [subject]
Previous message: [M]: LX200: Entering RA/Dec to sync, Evan Zucker
Next message: [M]: RE: 416xt SCSI settings, Heapy Chris CG
Next message in thread: [M]: RE: 416xt SCSI settings, Heapy Chris CG
Previous message in thread: [M]: 416xt SCSI settings, Email address hidden