This happened after trying to run ACP with his scope. I have heard of
a case where a ground loop between the computer and the scope caused
the RS-232 connection to fry the scope controller, but then it showed
no signs of life. His appears to start partially, then hangs on
"Meade". Does anyone know of a key-press combination or ??? that will
force the scope controller into a "reset" or other known state?

-- Bob

Alf Jacob Nilsen wrote:
> Help please! I installed the DC3 dreams LX200 operating software, but
> after trying to connect the program to my LX200 (ver. 3.3), the scope's
> software stopped running. Now I cannot get it going again. The keypad
> displays "Meade" and that's it! Any idea what might be the problem and
> what i can do ??

View index by [date] [author] [subject]
Previous message: [M]: LX 200 alignment stars question, Dennis
Next message: [M]: ST-7E autoguder cable pinouts?, Ray Gralak
Next message in thread: Re: [M]: LX200 software problems!, Chris Vedeler
Previous message in thread: [M]: LX200 software problems!, Alf Jacob Nilsen