[M]: Re: Re: Thumb Screws for Collimation (again)
| Subject: | [M]: Re: Re: Thumb Screws for Collimation (again) |
| From: | Shay Walters |
| Date: | Thu Dec 02 09:26:13 1999 |
One thing I recall that came up earlier about these screws is if you have an
F/6.3 scope, the screws are quite a bit longer. (I dont remember how long,
but I think it was on the order of 3 inches.)
-----Original Message-----
From: Joe Torelli
To: mapug@shore.net
Date: Thursday, December 02, 1999 7:07 AM
Subject: [M]: Re: Thumb Screws for Collimation (again)
>I have seen it posted here although I have not ordered any yet.
>The screws are 6-32
>>From McMaster Carr
>P# 91746A128
>Description: #6-32 Size x 1/2" Long, 1/8" Height, 3/8" Diameter, 18-8
>Stainless Steel Knurled Head Flat point thumb screws.
>Should be $10 ppd.
>#6 washers or 1/8" nylon spacers may be required
>_________________________
>
F/6.3 scope, the screws are quite a bit longer. (I dont remember how long,
but I think it was on the order of 3 inches.)
-----Original Message-----
From: Joe Torelli
To: mapug@shore.net
Date: Thursday, December 02, 1999 7:07 AM
Subject: [M]: Re: Thumb Screws for Collimation (again)
>I have seen it posted here although I have not ordered any yet.
>The screws are 6-32
>>From McMaster Carr
>P# 91746A128
>Description: #6-32 Size x 1/2" Long, 1/8" Height, 3/8" Diameter, 18-8
>Stainless Steel Knurled Head Flat point thumb screws.
>Should be $10 ppd.
>#6 washers or 1/8" nylon spacers may be required
>_________________________
>
