Paul,

FWIW, I was suggesting he check the connection of the two
wires that actually terminate on the motor itself. The solder
connection on mine had broke, but was not readily obvious
due to the fact that the wire still "looked" attached because
of the shrink tubing used at the connection. Only after I
wiggled it, did it come off.

Mike McAuley
Tucson, Arizona

----- Original Message -----
Sent: Monday, December 06, 1999 2:28 PM
Subject: Re: [M]: Re: Re: Dec dead


> At 04:49 PM 12/6/99 -0400, you wrote:
> >Mike:
> >
> >Will ck the wires tonight and let you know if that was the problem. We
ckd
> >the wires but did not take
> >a close look could be the same as yours will take a closer look. Thanks
for
> >the advice.
>
> If you are trying to make a straight through cable (ie., pin 1 to pin 1,
> etc.) the colors should be in the same sequence when the connectors are
> placed side by side with the cables exiting the same direction. If the
> colors line up one for one with the connectors placed end to end they are
> wired as crossover.
>
> Been there, been fooled myself!
>
>
>
>

View index by [date] [author] [subject]
Previous message: [M]: Pictor 201XT: Problems using with an LX50, Email address hidden
Next message: Re: [M]: ETX Power, Clark Williams
Next message in thread: Re: [M]: Re: Re: Dec dead, john Fraser
Previous message in thread: Re: [M]: Re: Re: Dec dead, Paul Goelz