>I know this is OT but I have a
>question about a circut board.
>While looking at my circut boards
>for my encoders I noticed that the
>metal on the board to the soldered
>pin was starting to lift off-so much
>in fact that 1 pin was not
>connected. Is there a repair for
>this or must I purchase a new board

G'day Carl. I had a similar problem with my Magellan II on my
LX50. It can be repaired. You need some fine insulated wire and
a small soldering iron. Just connect the wire to the same points
that the track on the circuit board connect to. My Magellan II was
dead straight out of the box and I had to repair one of the circuit
boards in 3 places, ( works well now ).

View index by [date] [author] [subject]
Previous message: Re: [M]: 8th Mag. naked eye?, Ric L Ecker
Next message: [M]: Re: LX50 "SURGE" problem - please help, Geoff Taurins
Previous message in thread: Re: [M]: Circut Board Repair Possible?, Dave Sage