Sponsored By:

Subject: Re: Quick align for your finder
From: Cliff Peterson
Reply To: mapug@shore.net
Date: Wed Jul 19 00:49:44 1995

> If you want to eliminate alignment of your Meade finder each time you set
> up your scope, do what I have done with mine. On the side of the bracket
> where the two nylon screws hold the finder, cut a "V" groove exactly aligned
> with the nylon hold down screws. Sharpen both screws to fit into the "V"
> groove, which force it to register to the same place each time. I never,
> ever have to align the finder. Several others has done this in our club
> after seeing mine.
> P.S. have a machinist cut the "V" groove........................ric

Ric --- This makes really good sense and I will be doing it soon. Meade should consider doing this and make a great product even better. Not all good ideas come from their design engineers.

Cliff

* * * * * * * * * * * * * * * * * * * * * * * * Cliff Peterson Computer Specialist * * Weber State University * * Applied Science & Technology * * Ogden, UT 84408-1801 * * Tel: (801) 626-7590 FAX: (801) 626-6987 * * Internet cpeterson@cc.weber.edu * * * * * * * * * * * * * * * * * * * * * * * *