Sponsored By:
[index] [month] [prev] [next] [thead-prev] [thread-next]

Subject: Re: [M]: LX Heat Sink WARNING!!!!
From: Rob Roy
Reply To: mapug@shore.net
Date: Sun Jul 20 05:35:36 1997

>I anyone runs the LX 200 with the bottom cover plate removed, be warned
>that the cover plate is part of the heat sink structure. The driver
>transistors can easily overheat when the thermal path from the internal
>heat sinks to the cover plate is interrupted.
>
>There are two screws holding the cover plate to the heat sink structure
>for this reason.
>
>Be careful about this!!!
>
>Doc G
>
Oops! I have run the scope several times for adjustments, greasing, etc. I
never even thought of that. Nothing seems to have been hurt, however. Will
make up some sort of little plate to attach temporarily for future RA drive
ventures.

Thanks for the thought, Doc.

Rob


View index by [date] [author] [subject]
Previous message: Re: [M]: R/A Drive Noise!!!, Ken Shouse
Next message: [M]: Alignment at "Site Unknown", David Steinberg
Next message in thread: Re: [M]: LX Heat Sink WARNING!!!!, DBaker1047@aol.com
Previous message in thread: [M]: LX Heat Sink WARNING!!!!, R. A. Greiner